Center Frame Section (TAC-231D-S) Set

Description

Our TAC-231D was designed to fit the 2nd gen Tacoma Double cab center frame.  This part begins 13.5″ after the trans cross member and ends just before the forward fuel tank cross member where the frame curves up over the rear axle.

Made from American 11ga steel that meets or exceeds the factory used steel.

TAC-231D-S is a set of both Driver side and Passenger side frame kits.

Installation Instructions included with each Frame Kit.

Caps over the original frame from underneath then welds to the upper edge, and lower inner edge of the original frame as well as the front and rear seems.

This Kit fits standard 5 ft bed 4WD vehicle ONLY!

PLEASE NOTE: If you have a 2WD truck or a LONG BED please give us a call.

We Make the Kits that Fit!